Upper Cover Plate
- 1/8 inch drill bit.
- (6) #8 pop rivets.
- Pop rivet gun.
- Fit the upper cover plate into the top of the cavity per the sketches below.
- Make sure the cover plate is flush against the top of the cavity and all the way back. Cover plates will install in all cavities the same way.
- Holding the upper cover plate in position and using the pre-drilled ho9le in the cover plate as a locator, drill a hole in the vertical member at point "A" and pop rivet into place. Move over to the other side of the cabinet and to the same think at point "B".
- Move to the front of the cabinet, point "C", and using the four pre-drilled holes as locators drill and pop rivet the cover plate to the top member in the four places shown on the sketch below.
Most departments are available 8 am to 5 pm Monday to Friday except holidays.